Scroll Saw Inlay Angle. the key is the proper angle for the blade and the final thickness of the. I set my angle with a wixie but you can also do it by trail. getting an accurate inlay cut with the blade set at a 90 degrees. Not being able to use the double bevel angle meant. I set my angle with a wixie. i have one of my scroll saws set to 2.2 degrees, approximately, that i use only for inlays. I do inlay and always hot. The bit enters on the inlay side of the pattern line on the top piece of wood and exits on the waste side of the inlay section on the bottom stock. i have one of my scroll saws set to 2.2 degrees, approximately, that i use only for inlays. A slightly steeper angle is better than not enough. as an example, with 1/4 thick wood, and a #5 scroll saw blade ( 0.016 kerf), the required angle is 3.7 degrees. i use all 3/8 thickness wood with a #5 or #7 blade and tilt my table on my saw about 2.2â°.
from forum.shopsmith.com
I do inlay and always hot. getting an accurate inlay cut with the blade set at a 90 degrees. Not being able to use the double bevel angle meant. i have one of my scroll saws set to 2.2 degrees, approximately, that i use only for inlays. as an example, with 1/4 thick wood, and a #5 scroll saw blade ( 0.016 kerf), the required angle is 3.7 degrees. the key is the proper angle for the blade and the final thickness of the. i have one of my scroll saws set to 2.2 degrees, approximately, that i use only for inlays. I set my angle with a wixie. I set my angle with a wixie but you can also do it by trail. The bit enters on the inlay side of the pattern line on the top piece of wood and exits on the waste side of the inlay section on the bottom stock.
Scroll Saw Inlay Question About Double Bevel Technique Shopsmith Forums
Scroll Saw Inlay Angle getting an accurate inlay cut with the blade set at a 90 degrees. I set my angle with a wixie. Not being able to use the double bevel angle meant. i have one of my scroll saws set to 2.2 degrees, approximately, that i use only for inlays. I do inlay and always hot. as an example, with 1/4 thick wood, and a #5 scroll saw blade ( 0.016 kerf), the required angle is 3.7 degrees. getting an accurate inlay cut with the blade set at a 90 degrees. i have one of my scroll saws set to 2.2 degrees, approximately, that i use only for inlays. The bit enters on the inlay side of the pattern line on the top piece of wood and exits on the waste side of the inlay section on the bottom stock. A slightly steeper angle is better than not enough. the key is the proper angle for the blade and the final thickness of the. I set my angle with a wixie but you can also do it by trail. i use all 3/8 thickness wood with a #5 or #7 blade and tilt my table on my saw about 2.2â°.